Stick-on invisible bra under the dress

Invisible adhesive bra with additional transparent tape to lift the bust. Soft shaped adhesive pads with a push-up effect completely replace a regular bra.

The bra can be used repeatedly. Ideal under dance dresses with a bare back and wherever you need your bra not to be seen at all.

This bra has a thick layer of silicone adhesive that is non-toxic and safe to use on the body. Please read the instructions for use here on our website before use.

When used correctly, this bra can be used repeatedly.

How to use:

1. wash your breasts and cleavage very thoroughly with soap.

2. dry the breasts and cleavage thoroughly with a dry towel.

3. unfasten the cups in the middle in the fastening.

4. grab one cup and carefully peel off the transparent protective film from one cup. Keep this foil though, you'll need it when you take the bra off! Put it in a bag so it doesn't get dusty and hide it somewhere where you'll find it later :-)

5. then look for another square-shaped bag in the package, where transparent stickers for bust lift are pasted. They are shaped like owls. Remove these stickers from the foil (but keep them here) and stick them to the edge of the cupcake as shown in one of the photos. As if with the pointed ears of an owl upwards.

6. point the cup in the right direction so that the fastening is down between the breasts. On the adhesive surface of the cup you can see a round hole where there is no adhesive layer - this is the place to store the nipple. So try to adjust the cup so that the nipple reaches this empty space.

7. glue the cup first to the lower part of the breast, make sure that you really start from the very lowest part of the bust and continue to glue upwards, try to point the nipple correctly to the empty hole and then try to glue the bra so that your breast is as high and voluminous as possible.

8. when you have glued the cup, continue upwards to stick the transparent tape on the neckline. TIP: if your breasts are far apart, it is advisable to leave the top transparent tape on until after you have connected both cups together by fastening.

9. repeat everything on the second cup. After sticking both cups, place your hands on them and press the cups firmly against the bust for at least 10 seconds.

10 then connect the two cups using the central fastening. The resulting effect should be such that your breasts are perfectly lifted and thanks to the fact that they are pulled together, they create a full, beautiful cleavage.

Removal procedure:

1. unfasten the bra in the middle of the cups.

2. carefully slowly peel off the top part of the owl-shaped transparent foil first and work your way down to the breast. Leave the top owl sticker permanently attached to the bra. Hold the breast up with your hand while peeling it off. Repeat the same for the second cup.

3. soap the inner silicone part of the cups and foil with natural, non-aggressive soap.

4. rinse the entire inner part of the cup with running lukewarm water. However, do not squeeze or squeeze anything, just rinse the foam with water.

5. let the bra dry freely, for example on a hanger.

6. after drying, stick the film back on the sticky silicone part, which you saved well when removing it, first stick it on the main cup and then the smaller film on the transparent silicone top sticker (owl).

7. store the entire bra in a bag and in the closet. Do not leave in direct sunlight and without a bag. In this way, the bra is ready for further use and will serve you for many uses if you follow this procedure.

You can find this guide in cartoon form on the last photo.

Material: lycra, nylon, silicone.

Color: flesh

Size: B cups, ideal for sizes: 75B (34B), 80B (36B), 85A (38A), 70C (32C)

Care: gentle hand wash only, described above in the removal description.